EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PD2ATG-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD2ATG-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RX*	Digi*
1761101038	205 Count	43 Count
1761099238	198 Count	41 Count
1761097437	186 Count	39 Count
1761095638	179 Count	37 Count
1761093838	167 Count	35 Count
1761092037	157 Count	33 Count
1761090237	147 Count	31 Count
1761088437	142 Count	30 Count
1761086637	131 Count	28 Count
1761084837	125 Count	26 Count
1761083037	117 Count	25 Count
1761081237	107 Count	23 Count
1761079437	97 Count	21 Count
1761077637	89 Count	19 Count
1761075837	82 Count	18 Count
1761074036	72 Count	16 Count
1761072236	62 Count	14 Count
1761070436	56 Count	13 Count
1761068635	46 Count	11 Count
1761066835	38 Count	9 Count
1761065035	32 Count	7 Count
1761063235	24 Count	6 Count
1761061435	15 Count	4 Count
1761057835	1003 Count	236 Count
1761056035	998 Count	234 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)