EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

CT2IKC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CT2IKC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1756550651	234 Count	389 Count	185 Count
1756548847	231 Count	385 Count	183 Count
1756547043	221 Count	350 Count	174 Count
1756545240	210 Count	331 Count	164 Count
1756543436	207 Count	327 Count	162 Count
1756541632	204 Count	323 Count	160 Count
1756539829	201 Count	319 Count	158 Count
1756538068	198 Count	315 Count	156 Count
1756536264	195 Count	311 Count	154 Count
1756534461	192 Count	307 Count	152 Count
1756532657	189 Count	303 Count	150 Count
1756530854	186 Count	299 Count	148 Count
1756529050	183 Count	295 Count	146 Count
1756527247	179 Count	289 Count	143 Count
1756525442	174 Count	281 Count	139 Count
1756523639	168 Count	271 Count	134 Count
1756521835	163 Count	264 Count	130 Count
1756520032	159 Count	258 Count	127 Count
1756518228	155 Count	252 Count	124 Count
1756516467	151 Count	247 Count	121 Count
1756514663	148 Count	243 Count	119 Count
1756512860	145 Count	239 Count	117 Count
1756511056	142 Count	235 Count	115 Count
1756509253	138 Count	231 Count	112 Count
1756507449	135 Count	227 Count	110 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)