EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773746863	104 Count	247 Count	68 Count
1773746442	101 Count	240 Count	66 Count
1773746021	98 Count	233 Count	64 Count
1773745601	96 Count	228 Count	63 Count
1773745180	93 Count	219 Count	61 Count
1773744759	90 Count	210 Count	59 Count
1773744339	86 Count	203 Count	56 Count
1773743918	84 Count	197 Count	55 Count
1773743498	81 Count	191 Count	53 Count
1773743077	78 Count	183 Count	51 Count
1773742656	76 Count	179 Count	50 Count
1773742236	72 Count	171 Count	47 Count
1773741815	70 Count	167 Count	46 Count
1773741394	67 Count	161 Count	44 Count
1773740974	64 Count	150 Count	42 Count
1773740553	60 Count	146 Count	39 Count
1773740132	58 Count	140 Count	38 Count
1773739712	56 Count	139 Count	37 Count
1773739291	52 Count	130 Count	34 Count
1773738870	49 Count	124 Count	32 Count
1773738450	47 Count	119 Count	31 Count
1773738029	44 Count	114 Count	29 Count
1773737608	41 Count	104 Count	27 Count
1773737187	38 Count	98 Count	25 Count
1773736767	35 Count	85 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)