EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777876520	337 Count	839 Count	238 Count
1777876100	332 Count	829 Count	234 Count
1777875679	330 Count	816 Count	233 Count
1777875259	323 Count	798 Count	227 Count
1777874838	322 Count	793 Count	227 Count
1777874418	316 Count	778 Count	222 Count
1777873997	311 Count	767 Count	218 Count
1777873576	308 Count	759 Count	216 Count
1777873156	304 Count	748 Count	213 Count
1777872735	300 Count	733 Count	210 Count
1777872314	296 Count	719 Count	207 Count
1777871894	292 Count	710 Count	204 Count
1777871473	286 Count	699 Count	200 Count
1777871324	281 Count	696 Count	199 Count
1777870904	278 Count	688 Count	197 Count
1777870483	271 Count	675 Count	191 Count
1777870062	268 Count	670 Count	189 Count
1777869642	264 Count	658 Count	186 Count
1777869221	261 Count	650 Count	184 Count
1777868800	258 Count	642 Count	182 Count
1777868380	256 Count	637 Count	181 Count
1777867959	247 Count	620 Count	173 Count
1777867539	245 Count	613 Count	172 Count
1777867118	241 Count	603 Count	169 Count
1777866698	239 Count	583 Count	168 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)