EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765067340	4 Count	4 Count	2 Count
1765066434	1003 Count	625 Count	367 Count
1765065528	998 Count	621 Count	364 Count
1765064623	994 Count	619 Count	363 Count
1765063717	990 Count	615 Count	361 Count
1765062811	986 Count	613 Count	360 Count
1765061906	983 Count	611 Count	359 Count
1765061000	979 Count	609 Count	358 Count
1765060094	976 Count	608 Count	357 Count
1765059189	970 Count	604 Count	355 Count
1765058283	967 Count	601 Count	354 Count
1765057377	961 Count	596 Count	351 Count
1765056472	958 Count	595 Count	350 Count
1765055566	954 Count	591 Count	349 Count
1765054660	950 Count	586 Count	347 Count
1765053754	945 Count	583 Count	345 Count
1765052849	943 Count	583 Count	345 Count
1765051943	939 Count	582 Count	344 Count
1765051037	937 Count	581 Count	344 Count
1765050132	934 Count	580 Count	344 Count
1765049225	931 Count	577 Count	343 Count
1765048319	927 Count	574 Count	342 Count
1765047413	924 Count	572 Count	341 Count
1765046507	918 Count	567 Count	338 Count
1765045601	911 Count	561 Count	334 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)