EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1767303301	30 Count	286 Count
1767302400	26 Count	180 Count
1767301500	23 Count	165 Count
1767300599	21 Count	130 Count
1767299698	19 Count	122 Count
1767298797	16 Count	105 Count
1767297896	14 Count	98 Count
1767296995	11 Count	79 Count
1767296095	9 Count	67 Count
1767295194	6 Count	28 Count
1767294293	4 Count	13 Count
1767293392	1 Count	6 Count
1767292491	56 Count	1013 Count
1767291590	53 Count	1000 Count
1767290689	51 Count	992 Count
1767289789	49 Count	982 Count
1767288888	46 Count	960 Count
1767287987	43 Count	917 Count
1767287085	41 Count	910 Count
1767286184	39 Count	828 Count
1767285283	36 Count	744 Count
1767284383	32 Count	652 Count
1767283482	30 Count	637 Count
1767282581	28 Count	565 Count
1767281680	26 Count	474 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)