EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1771844184	17 Count	745 Count
1771843283	14 Count	635 Count
1771842382	13 Count	515 Count
1771841482	10 Count	418 Count
1771840581	9 Count	338 Count
1771839680	4 Count	246 Count
1771838779	3 Count	116 Count
1771837878	33 Count	1094 Count
1771836977	28 Count	985 Count
1771836077	24 Count	863 Count
1771835176	23 Count	729 Count
1771834275	20 Count	640 Count
1771833374	18 Count	598 Count
1771832473	13 Count	480 Count
1771831572	10 Count	372 Count
1771830671	7 Count	277 Count
1771829770	6 Count	209 Count
1771828870	2 Count	111 Count
1771827969	30 Count	1028 Count
1771827068	27 Count	909 Count
1771826167	26 Count	881 Count
1771825266	21 Count	785 Count
1771824365	20 Count	680 Count
1771823464	16 Count	587 Count
1771822564	14 Count	484 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)