EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5STR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790616981	101 Count	851 Count
1790615181	100 Count	795 Count
1790613380	99 Count	743 Count
1790611579	98 Count	716 Count
1790609788	97 Count	692 Count
1790607987	96 Count	669 Count
1790606186	95 Count	647 Count
1790604386	94 Count	630 Count
1790602585	92 Count	610 Count
1790600784	91 Count	586 Count
1790598983	90 Count	566 Count
1790597183	89 Count	539 Count
1790595382	88 Count	487 Count
1790593581	87 Count	430 Count
1790591780	86 Count	381 Count
1790589980	85 Count	357 Count
1790588188	70 Count	330 Count
1790586388	57 Count	310 Count
1790584587	46 Count	232 Count
1790582786	26 Count	155 Count
1790580985	11 Count	72 Count
1790579184	62 Count	1009 Count
1790577383	51 Count	935 Count
1790575583	43 Count	852 Count
1790573782	42 Count	817 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)