EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762519198	904 Count	955 Count	492 Count
1762518295	901 Count	952 Count	490 Count
1762517392	898 Count	948 Count	488 Count
1762516489	894 Count	942 Count	485 Count
1762515586	885 Count	926 Count	477 Count
1762514683	879 Count	918 Count	472 Count
1762513780	876 Count	914 Count	470 Count
1762512877	873 Count	910 Count	468 Count
1762511974	870 Count	906 Count	466 Count
1762511071	867 Count	902 Count	464 Count
1762510240	865 Count	900 Count	463 Count
1762509337	861 Count	894 Count	460 Count
1762508433	858 Count	890 Count	458 Count
1762507530	853 Count	882 Count	454 Count
1762506627	848 Count	874 Count	450 Count
1762505724	845 Count	870 Count	448 Count
1762504821	842 Count	866 Count	446 Count
1762503918	839 Count	863 Count	444 Count
1762503015	836 Count	861 Count	442 Count
1762502112	833 Count	857 Count	440 Count
1762501209	829 Count	851 Count	437 Count
1762500306	825 Count	847 Count	434 Count
1762499403	822 Count	843 Count	432 Count
1762498500	819 Count	839 Count	430 Count
1762497597	816 Count	835 Count	428 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)