EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769937237	994 Count	930 Count	499 Count
1769936333	992 Count	928 Count	498 Count
1769935430	990 Count	926 Count	497 Count
1769934527	988 Count	924 Count	496 Count
1769933624	986 Count	922 Count	495 Count
1769932721	984 Count	920 Count	494 Count
1769931818	982 Count	918 Count	493 Count
1769930915	980 Count	916 Count	492 Count
1769930012	977 Count	913 Count	490 Count
1769929109	975 Count	911 Count	489 Count
1769928206	973 Count	909 Count	488 Count
1769927303	971 Count	907 Count	487 Count
1769926400	969 Count	905 Count	486 Count
1769925497	967 Count	903 Count	485 Count
1769924594	965 Count	901 Count	484 Count
1769923691	963 Count	899 Count	483 Count
1769922788	961 Count	897 Count	482 Count
1769921885	959 Count	896 Count	481 Count
1769920982	957 Count	894 Count	480 Count
1769919248	953 Count	891 Count	478 Count
1769918345	951 Count	889 Count	477 Count
1769917442	949 Count	887 Count	476 Count
1769916539	947 Count	885 Count	475 Count
1769915636	945 Count	883 Count	474 Count
1769914733	943 Count	881 Count	473 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)