EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767302384	30 Count	342 Count	27 Count
1767300583	23 Count	243 Count	21 Count
1767298783	13 Count	140 Count	12 Count
1767296982	6 Count	73 Count	6 Count
1767295181	114 Count	1151 Count	100 Count
1767293381	106 Count	994 Count	93 Count
1767291580	98 Count	926 Count	86 Count
1767289786	90 Count	852 Count	79 Count
1767287986	85 Count	777 Count	75 Count
1767286185	73 Count	701 Count	64 Count
1767284384	66 Count	640 Count	58 Count
1767282584	59 Count	572 Count	52 Count
1767280783	51 Count	493 Count	45 Count
1767278983	42 Count	424 Count	37 Count
1767277182	34 Count	333 Count	30 Count
1767275381	26 Count	243 Count	23 Count
1767273581	18 Count	160 Count	16 Count
1767271780	9 Count	72 Count	8 Count
1767269980	0 Count	0 Count	0 Count
1767268186	88 Count	920 Count	77 Count
1767266385	82 Count	857 Count	72 Count
1767264584	69 Count	784 Count	60 Count
1767260983	53 Count	608 Count	46 Count
1767259183	44 Count	518 Count	38 Count
1767257382	37 Count	436 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)