EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767981639	41 Count	469 Count	39 Count
1767979839	32 Count	373 Count	31 Count
1767978038	12 Count	172 Count	12 Count
1767976236	61 Count	1081 Count	54 Count
1767974436	52 Count	973 Count	46 Count
1767972635	45 Count	853 Count	40 Count
1767970835	33 Count	701 Count	29 Count
1767969041	25 Count	584 Count	22 Count
1767967240	18 Count	456 Count	16 Count
1767965439	12 Count	317 Count	11 Count
1767963639	5 Count	180 Count	5 Count
1767961838	86 Count	1030 Count	79 Count
1767960038	78 Count	883 Count	72 Count
1767958237	71 Count	753 Count	66 Count
1767956437	61 Count	635 Count	57 Count
1767954636	48 Count	511 Count	45 Count
1767952835	30 Count	385 Count	28 Count
1767951035	20 Count	280 Count	19 Count
1767949234	12 Count	146 Count	12 Count
1767947440	97 Count	1147 Count	89 Count
1767945639	84 Count	953 Count	77 Count
1767943839	74 Count	827 Count	68 Count
1767942038	63 Count	736 Count	58 Count
1767940238	54 Count	619 Count	50 Count
1767938437	43 Count	502 Count	40 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)