EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8MB-L Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8MB-L. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1756553588	597 Count	90 Count	83 Count
1756553467	595 Count	89 Count	82 Count
1756553346	594 Count	89 Count	82 Count
1756553225	592 Count	88 Count	81 Count
1756553104	591 Count	88 Count	81 Count
1756552984	590 Count	88 Count	81 Count
1756552863	589 Count	88 Count	81 Count
1756552742	588 Count	88 Count	81 Count
1756552621	585 Count	86 Count	79 Count
1756552500	584 Count	86 Count	79 Count
1756552379	583 Count	86 Count	79 Count
1756552258	582 Count	86 Count	79 Count
1756552137	581 Count	86 Count	79 Count
1756552017	579 Count	85 Count	78 Count
1756551896	578 Count	85 Count	78 Count
1756551775	577 Count	85 Count	78 Count
1756551654	575 Count	84 Count	77 Count
1756551532	574 Count	84 Count	77 Count
1756551411	573 Count	84 Count	77 Count
1756551290	572 Count	84 Count	77 Count
1756551170	571 Count	84 Count	77 Count
1756551049	570 Count	84 Count	77 Count
1756550928	569 Count	84 Count	77 Count
1756550807	567 Count	83 Count	76 Count
1756550686	566 Count	83 Count	76 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)