EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789237549	325 Count	475 Count	310 Count
1789236949	300 Count	435 Count	286 Count
1789236348	278 Count	401 Count	265 Count
1789235747	252 Count	360 Count	240 Count
1789235147	222 Count	316 Count	211 Count
1789233945	166 Count	232 Count	157 Count
1789233344	136 Count	184 Count	128 Count
1789232771	108 Count	150 Count	105 Count
1789232170	78 Count	106 Count	76 Count
1789231569	49 Count	64 Count	48 Count
1789230967	25 Count	35 Count	25 Count
1789230366	669 Count	1031 Count	642 Count
1789229766	644 Count	993 Count	618 Count
1789229165	621 Count	957 Count	596 Count
1789228564	595 Count	920 Count	571 Count
1789227964	571 Count	882 Count	548 Count
1789227363	547 Count	846 Count	525 Count
1789226762	520 Count	809 Count	499 Count
1789226161	497 Count	775 Count	477 Count
1789225560	470 Count	735 Count	451 Count
1789224960	444 Count	693 Count	426 Count
1789224359	418 Count	655 Count	401 Count
1789223758	399 Count	631 Count	383 Count
1789223161	372 Count	587 Count	357 Count
1789222557	348 Count	549 Count	334 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)