EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788952527	287 Count	780 Count	221 Count
1788951952	281 Count	774 Count	220 Count
1788951351	273 Count	761 Count	213 Count
1788950750	260 Count	743 Count	201 Count
1788950149	259 Count	732 Count	201 Count
1788949548	250 Count	717 Count	193 Count
1788948948	247 Count	708 Count	191 Count
1788948347	245 Count	701 Count	190 Count
1788947746	241 Count	691 Count	187 Count
1788947146	234 Count	677 Count	181 Count
1788946545	233 Count	672 Count	181 Count
1788945944	227 Count	658 Count	176 Count
1788945344	223 Count	651 Count	173 Count
1788944743	221 Count	644 Count	172 Count
1788944142	216 Count	633 Count	168 Count
1788943541	212 Count	623 Count	165 Count
1788942941	211 Count	619 Count	165 Count
1788942340	205 Count	607 Count	160 Count
1788941739	201 Count	598 Count	157 Count
1788941139	199 Count	589 Count	156 Count
1788940538	194 Count	579 Count	152 Count
1788939937	188 Count	568 Count	147 Count
1788939336	186 Count	562 Count	146 Count
1788938736	179 Count	548 Count	140 Count
1788938135	173 Count	536 Count	135 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)