EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IU3ISP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU3ISP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1782567302	37 Count	531 Count	20 Count
1782563694	33 Count	459 Count	18 Count
1782558282	24 Count	347 Count	12 Count
1782556479	21 Count	304 Count	10 Count
1782554675	18 Count	260 Count	8 Count
1782543895	1 Count	37 Count	1 Count
1782542091	68 Count	1048 Count	36 Count
1782538483	62 Count	961 Count	32 Count
1782536679	59 Count	909 Count	30 Count
1782533072	53 Count	836 Count	26 Count
1782531311	47 Count	785 Count	25 Count
1782524096	40 Count	630 Count	22 Count
1782522292	37 Count	592 Count	20 Count
1782516880	31 Count	479 Count	17 Count
1782493474	67 Count	926 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)