EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

DG4CB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG4CB-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1768199112	304 Count	463 Count
1768197309	303 Count	461 Count
1768195506	302 Count	459 Count
1768193703	301 Count	457 Count
1768191900	300 Count	455 Count
1768186491	297 Count	449 Count
1768184688	296 Count	447 Count
1768179279	293 Count	441 Count
1768177476	292 Count	439 Count
1768175673	291 Count	437 Count
1768173870	290 Count	435 Count
1768170264	288 Count	431 Count
1768168461	287 Count	429 Count
1768166658	286 Count	427 Count
1768164855	285 Count	425 Count
1768163052	284 Count	423 Count
1768157643	281 Count	417 Count
1768155840	280 Count	415 Count
1768141415	272 Count	399 Count
1768139612	271 Count	397 Count
1768137809	270 Count	395 Count
1768134203	268 Count	391 Count
1768130597	266 Count	387 Count
1768128794	265 Count	385 Count
1768126991	264 Count	383 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)