EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789240299	33 Count	598 Count	8 Count
1789239698	32 Count	566 Count	8 Count
1789239097	30 Count	540 Count	7 Count
1789238497	29 Count	509 Count	7 Count
1789237896	28 Count	486 Count	7 Count
1789237295	26 Count	464 Count	6 Count
1789236695	25 Count	436 Count	6 Count
1789235493	22 Count	402 Count	5 Count
1789234892	21 Count	376 Count	5 Count
1789233691	19 Count	336 Count	5 Count
1789233090	18 Count	315 Count	5 Count
1789231288	14 Count	246 Count	4 Count
1789230687	12 Count	225 Count	3 Count
1789230086	11 Count	206 Count	3 Count
1789229485	10 Count	184 Count	3 Count
1789228885	8 Count	159 Count	2 Count
1789228284	7 Count	138 Count	2 Count
1789227683	6 Count	113 Count	2 Count
1789227082	4 Count	84 Count	1 Count
1789226482	3 Count	61 Count	1 Count
1789225881	2 Count	39 Count	1 Count
1789225280	0 Count	23 Count	0 Count
1789224679	68 Count	1007 Count	27 Count
1789224079	67 Count	983 Count	27 Count
1789222877	64 Count	933 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)