EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765128574	249 Count	824 Count	38 Count
1765127973	248 Count	821 Count	38 Count
1765127373	247 Count	819 Count	38 Count
1765126773	246 Count	812 Count	38 Count
1765126171	245 Count	811 Count	38 Count
1765125570	244 Count	807 Count	38 Count
1765124970	243 Count	800 Count	38 Count
1765124369	242 Count	796 Count	38 Count
1765123768	241 Count	793 Count	38 Count
1765123167	240 Count	787 Count	38 Count
1765122566	239 Count	784 Count	38 Count
1765121965	238 Count	780 Count	38 Count
1765121365	235 Count	774 Count	36 Count
1765120764	234 Count	771 Count	36 Count
1765120163	233 Count	767 Count	36 Count
1765119562	232 Count	762 Count	36 Count
1765118962	231 Count	759 Count	36 Count
1765118361	230 Count	756 Count	36 Count
1765117760	229 Count	750 Count	36 Count
1765117159	228 Count	748 Count	36 Count
1765116558	227 Count	745 Count	36 Count
1765115958	226 Count	740 Count	36 Count
1765115357	225 Count	736 Count	36 Count
1765114756	224 Count	731 Count	36 Count
1765114155	223 Count	726 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)