EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1767322591	128 Count	681 Count	1 Count
1767321391	127 Count	674 Count	1 Count
1767320190	126 Count	666 Count	1 Count
1767318989	125 Count	658 Count	1 Count
1767317789	124 Count	651 Count	1 Count
1767316588	123 Count	642 Count	1 Count
1767315388	122 Count	629 Count	1 Count
1767314187	121 Count	623 Count	1 Count
1767312986	120 Count	614 Count	1 Count
1767311786	119 Count	603 Count	1 Count
1767310585	118 Count	597 Count	1 Count
1767309385	117 Count	588 Count	1 Count
1767308184	116 Count	577 Count	1 Count
1767306983	115 Count	571 Count	1 Count
1767305783	114 Count	563 Count	1 Count
1767304594	108 Count	552 Count	0 Count
1767303394	107 Count	543 Count	0 Count
1767302193	106 Count	535 Count	0 Count
1767300990	105 Count	520 Count	0 Count
1767299789	104 Count	514 Count	0 Count
1767298589	103 Count	505 Count	0 Count
1767297388	100 Count	495 Count	0 Count
1767296188	82 Count	489 Count	0 Count
1767294987	70 Count	481 Count	0 Count
1767293786	69 Count	471 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)