EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1GDK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1757859505	69 Count	275 Count
1757858905	68 Count	271 Count
1757858303	67 Count	269 Count
1757857703	66 Count	263 Count
1757857102	65 Count	263 Count
1757856501	64 Count	257 Count
1757855900	63 Count	255 Count
1757855300	62 Count	249 Count
1757854699	61 Count	247 Count
1757854098	60 Count	241 Count
1757853497	59 Count	240 Count
1757852897	58 Count	232 Count
1757852296	57 Count	230 Count
1757851695	56 Count	227 Count
1757851095	55 Count	224 Count
1757850494	54 Count	219 Count
1757849893	53 Count	218 Count
1757849318	52 Count	213 Count
1757848718	51 Count	210 Count
1757848117	50 Count	206 Count
1757847516	49 Count	204 Count
1757846915	48 Count	199 Count
1757846315	47 Count	196 Count
1757845714	46 Count	190 Count
1757845113	45 Count	186 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)