EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1GDK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1762365831	58 Count	15 Count
1762365225	57 Count	15 Count
1762364619	56 Count	15 Count
1762364013	55 Count	14 Count
1762363407	54 Count	10 Count
1762362801	53 Count	10 Count
1762362194	52 Count	10 Count
1762361588	51 Count	10 Count
1762360982	50 Count	10 Count
1762360376	49 Count	10 Count
1762359769	48 Count	10 Count
1762359163	47 Count	10 Count
1762358557	46 Count	10 Count
1762357951	45 Count	10 Count
1762357345	44 Count	10 Count
1762356738	43 Count	9 Count
1762356132	42 Count	8 Count
1762355526	41 Count	8 Count
1762354314	39 Count	1 Count
1762353708	38 Count	0 Count
1762353101	37 Count	0 Count
1762352495	36 Count	0 Count
1762351889	35 Count	0 Count
1762351283	34 Count	0 Count
1762350677	33 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)