EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1GDK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1757111003	180 Count	736 Count	102 Count
1757109200	171 Count	728 Count	94 Count
1757107397	158 Count	716 Count	82 Count
1757105594	149 Count	708 Count	74 Count
1757103791	137 Count	697 Count	63 Count
1757101988	127 Count	688 Count	54 Count
1757100186	115 Count	677 Count	43 Count
1757098382	104 Count	667 Count	33 Count
1757096579	93 Count	657 Count	23 Count
1757094777	85 Count	650 Count	16 Count
1757092974	75 Count	641 Count	7 Count
1757091171	66 Count	634 Count	0 Count
1757091125	62 Count	633 Count	0 Count
1757087117	59 Count	585 Count	0 Count
1757087049	58 Count	585 Count	0 Count
1757086959	53 Count	585 Count	0 Count
1757084793	48 Count	585 Count	0 Count
1757082991	46 Count	578 Count	0 Count
1757082977	42 Count	578 Count	0 Count
1757081444	41 Count	571 Count	0 Count
1757079641	40 Count	566 Count	0 Count
1757077838	39 Count	558 Count	0 Count
1757077801	38 Count	558 Count	0 Count
1757077600	37 Count	558 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)