EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9KFZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9KFZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1757941977	92 Count	576 Count	52 Count
1757940177	83 Count	468 Count	44 Count
1757938376	76 Count	382 Count	38 Count
1757936575	69 Count	281 Count	32 Count
1757934775	54 Count	171 Count	18 Count
1757932974	46 Count	110 Count	11 Count
1757932968	45 Count	110 Count	11 Count
1757932923	44 Count	109 Count	11 Count
1757931524	43 Count	109 Count	11 Count
1757931396	41 Count	101 Count	10 Count
1757931287	40 Count	95 Count	10 Count
1757930218	33 Count	88 Count	9 Count
1757928418	27 Count	36 Count	5 Count
1757926993	20 Count	14 Count	2 Count
1757926911	18 Count	11 Count	1 Count
1757876556	4 Count	10 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)