EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IZ2WZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ2WZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1756575452	5 Count	106 Count
1756574548	4 Count	96 Count
1756573643	3 Count	75 Count
1756572738	2 Count	53 Count
1756571834	1 Count	39 Count
1756570929	0 Count	19 Count
1756570027	58 Count	1005 Count
1756569120	57 Count	984 Count
1756568655	56 Count	972 Count
1756567750	55 Count	963 Count
1756566846	54 Count	947 Count
1756565941	53 Count	927 Count
1756565037	52 Count	903 Count
1756564132	51 Count	874 Count
1756563228	50 Count	851 Count
1756562323	49 Count	830 Count
1756561418	48 Count	809 Count
1756560514	47 Count	796 Count
1756559609	46 Count	782 Count
1756558705	45 Count	760 Count
1756557800	44 Count	753 Count
1756556896	43 Count	738 Count
1756555991	42 Count	713 Count
1756555086	41 Count	689 Count
1756554182	40 Count	668 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)