EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5STR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1751687623	54 Count	499 Count
1751686722	53 Count	492 Count
1751685821	52 Count	483 Count
1751684921	51 Count	475 Count
1751684020	50 Count	469 Count
1751683119	49 Count	461 Count
1751682218	48 Count	454 Count
1751681318	47 Count	447 Count
1751680417	46 Count	440 Count
1751679516	45 Count	433 Count
1751678615	44 Count	426 Count
1751677734	43 Count	418 Count
1751676832	42 Count	411 Count
1751675931	41 Count	404 Count
1751675030	40 Count	396 Count
1751674129	39 Count	390 Count
1751673229	38 Count	383 Count
1751672328	37 Count	377 Count
1751671427	36 Count	370 Count
1751670526	35 Count	363 Count
1751669625	34 Count	355 Count
1751668725	33 Count	350 Count
1751667824	32 Count	344 Count
1751666923	31 Count	339 Count
1751666022	30 Count	333 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)