EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5STR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790997827	21 Count	912 Count
1790996026	20 Count	875 Count
1790994225	19 Count	839 Count
1790992425	18 Count	800 Count
1790990624	17 Count	763 Count
1790988823	16 Count	724 Count
1790987022	15 Count	684 Count
1790985222	14 Count	644 Count
1790983421	13 Count	604 Count
1790981620	12 Count	565 Count
1790979829	11 Count	518 Count
1790978028	10 Count	476 Count
1790976227	9 Count	429 Count
1790974427	8 Count	386 Count
1790972626	7 Count	337 Count
1790970825	6 Count	291 Count
1790969025	5 Count	250 Count
1790967224	4 Count	201 Count
1790965423	3 Count	139 Count
1790963622	2 Count	91 Count
1790961821	1 Count	48 Count
1790960021	0 Count	0 Count
1790958227	24 Count	982 Count
1790956427	23 Count	952 Count
1790954626	22 Count	919 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)