EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1OBR-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1781599701	480 Count	218 Count	60 Count
1781597897	479 Count	217 Count	60 Count
1781596094	478 Count	217 Count	60 Count
1781594290	477 Count	216 Count	60 Count
1781592486	475 Count	215 Count	59 Count
1781590682	472 Count	212 Count	57 Count
1781588924	469 Count	210 Count	55 Count
1781587120	468 Count	209 Count	55 Count
1781585316	467 Count	209 Count	55 Count
1781583512	466 Count	208 Count	55 Count
1781581708	465 Count	208 Count	55 Count
1781579904	460 Count	203 Count	51 Count
1781578101	459 Count	203 Count	51 Count
1781576297	458 Count	202 Count	51 Count
1781574493	457 Count	202 Count	51 Count
1781572689	456 Count	201 Count	51 Count
1781570885	455 Count	201 Count	51 Count
1781569081	454 Count	200 Count	51 Count
1781567323	453 Count	200 Count	51 Count
1781565520	452 Count	199 Count	51 Count
1781563715	451 Count	199 Count	51 Count
1781561911	450 Count	198 Count	51 Count
1781560108	449 Count	198 Count	51 Count
1781558304	448 Count	197 Count	51 Count
1781556500	447 Count	197 Count	51 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)