EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP9DAT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DAT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1743552933	228 Count	662 Count	204 Count
1743551131	195 Count	547 Count	174 Count
1743550230	180 Count	499 Count	160 Count
1743549329	160 Count	447 Count	143 Count
1743548428	145 Count	400 Count	129 Count
1743547527	128 Count	355 Count	114 Count
1743546627	112 Count	311 Count	99 Count
1743545726	97 Count	259 Count	86 Count
1743544825	86 Count	211 Count	76 Count
1743543924	65 Count	161 Count	58 Count
1743543023	48 Count	116 Count	42 Count
1743542122	30 Count	81 Count	27 Count
1743541221	17 Count	38 Count	15 Count
1743540320	397 Count	1046 Count	359 Count
1743539419	382 Count	969 Count	345 Count
1743538518	363 Count	903 Count	329 Count
1743537617	344 Count	850 Count	311 Count
1743536716	326 Count	819 Count	296 Count
1743535815	310 Count	774 Count	281 Count
1743534914	288 Count	723 Count	262 Count
1743534013	270 Count	671 Count	245 Count
1743533112	255 Count	635 Count	232 Count
1743532210	241 Count	591 Count	219 Count
1743531308	211 Count	525 Count	192 Count
1743530407	197 Count	492 Count	179 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)