EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1751660904	118 Count	231 Count
1751657302	111 Count	178 Count
1751653701	105 Count	118 Count
1751650099	103 Count	99 Count
1751646515	101 Count	99 Count
1751642913	99 Count	99 Count
1751639312	97 Count	99 Count
1751635711	95 Count	99 Count
1751632109	93 Count	99 Count
1751628508	91 Count	99 Count
1751624906	89 Count	99 Count
1751621305	87 Count	99 Count
1751617703	85 Count	98 Count
1751614102	83 Count	95 Count
1751610500	81 Count	93 Count
1751606899	79 Count	93 Count
1751603315	77 Count	92 Count
1751599713	75 Count	92 Count
1751596112	73 Count	92 Count
1751592510	71 Count	92 Count
1751588909	69 Count	92 Count
1751585307	67 Count	92 Count
1751581706	65 Count	91 Count
1751578104	63 Count	91 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)