EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1752077569	190 Count	206 Count	25 Count
1752073968	188 Count	206 Count	25 Count
1752070367	183 Count	203 Count	22 Count
1752066765	181 Count	203 Count	22 Count
1752063164	179 Count	203 Count	22 Count
1752059562	177 Count	203 Count	22 Count
1752055961	175 Count	203 Count	22 Count
1752052359	173 Count	203 Count	22 Count
1752048758	171 Count	203 Count	22 Count
1752045156	169 Count	203 Count	22 Count
1752041556	167 Count	203 Count	22 Count
1752038647	163 Count	203 Count	22 Count
1752035044	156 Count	198 Count	22 Count
1752031443	149 Count	194 Count	22 Count
1752027841	144 Count	184 Count	22 Count
1752024240	142 Count	176 Count	22 Count
1752020638	140 Count	172 Count	22 Count
1752017037	138 Count	170 Count	22 Count
1752013436	136 Count	167 Count	22 Count
1752009847	130 Count	158 Count	22 Count
1752006246	123 Count	156 Count	22 Count
1752002644	119 Count	144 Count	22 Count
1751999043	117 Count	133 Count	22 Count
1751995441	115 Count	129 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)