EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4JTC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4JTC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772088556	765 Count	761 Count	562 Count
1772088252	760 Count	757 Count	558 Count
1772087949	757 Count	754 Count	556 Count
1772087645	754 Count	750 Count	554 Count
1772087341	750 Count	743 Count	551 Count
1772087038	748 Count	742 Count	550 Count
1772086734	745 Count	739 Count	548 Count
1772086430	739 Count	733 Count	543 Count
1772086126	737 Count	731 Count	542 Count
1772085823	735 Count	729 Count	541 Count
1772085519	733 Count	725 Count	540 Count
1772085215	731 Count	723 Count	539 Count
1772084912	729 Count	720 Count	538 Count
1772084608	725 Count	717 Count	535 Count
1772084304	723 Count	715 Count	534 Count
1772084001	721 Count	712 Count	533 Count
1772083697	717 Count	709 Count	530 Count
1772083393	713 Count	706 Count	527 Count
1772083089	710 Count	703 Count	525 Count
1772082786	708 Count	701 Count	524 Count
1772082482	707 Count	701 Count	524 Count
1772082178	702 Count	696 Count	520 Count
1772081875	700 Count	695 Count	519 Count
1772081571	697 Count	693 Count	517 Count
1772081267	695 Count	691 Count	516 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)