EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

XE2AD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2AD-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1793192941	336 Count	334 Count	251 Count
1793191379	331 Count	334 Count	251 Count
1793189614	324 Count	330 Count	249 Count
1793187810	320 Count	326 Count	246 Count
1793186007	316 Count	322 Count	243 Count
1793184204	309 Count	316 Count	237 Count
1793182400	307 Count	315 Count	236 Count
1793180597	301 Count	310 Count	231 Count
1793178793	298 Count	306 Count	229 Count
1793176990	294 Count	302 Count	226 Count
1793175187	289 Count	297 Count	222 Count
1793173383	284 Count	292 Count	218 Count
1793171580	281 Count	289 Count	216 Count
1793168011	268 Count	281 Count	209 Count
1793166208	264 Count	278 Count	206 Count
1793164404	249 Count	262 Count	192 Count
1793162601	245 Count	259 Count	189 Count
1793160797	241 Count	254 Count	186 Count
1793158994	237 Count	248 Count	183 Count
1793157191	231 Count	240 Count	178 Count
1793155387	225 Count	231 Count	173 Count
1793153584	212 Count	218 Count	161 Count
1793151781	208 Count	212 Count	158 Count
1793149977	201 Count	204 Count	152 Count
1793146411	170 Count	169 Count	127 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)