EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789217248	152 Count	722 Count
1789215445	125 Count	657 Count
1789213679	112 Count	597 Count
1789211876	96 Count	515 Count
1789210073	84 Count	447 Count
1789208270	67 Count	374 Count
1789206466	45 Count	275 Count
1789204663	27 Count	174 Count
1789202860	15 Count	96 Count
1789201057	76 Count	1017 Count
1789199254	57 Count	939 Count
1789197451	41 Count	864 Count
1789195647	22 Count	778 Count
1789193844	13 Count	682 Count
1789192085	7 Count	602 Count
1789190282	6 Count	502 Count
1789188478	5 Count	402 Count
1789186676	4 Count	322 Count
1789184873	3 Count	258 Count
1789183069	2 Count	181 Count
1789181266	1 Count	113 Count
1789179463	0 Count	50 Count
1789177660	16 Count	1009 Count
1789175857	15 Count	939 Count
1789174054	14 Count	869 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)