EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1779702015	19 Count	855 Count
1779700212	18 Count	797 Count
1779698409	17 Count	749 Count
1779696606	16 Count	695 Count
1779694803	15 Count	641 Count
1779693000	14 Count	588 Count
1779691197	13 Count	529 Count
1779689394	12 Count	466 Count
1779687627	8 Count	410 Count
1779685824	7 Count	357 Count
1779684021	4 Count	291 Count
1779682217	3 Count	229 Count
1779680414	2 Count	177 Count
1779678611	1 Count	111 Count
1779676808	0 Count	59 Count
1779675005	17 Count	1024 Count
1779673202	16 Count	967 Count
1779671399	15 Count	883 Count
1779669596	14 Count	836 Count
1779667793	13 Count	791 Count
1779666027	12 Count	741 Count
1779664223	11 Count	685 Count
1779662420	9 Count	618 Count
1779660617	8 Count	556 Count
1779658814	7 Count	500 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)