EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

MB7ULR Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7ULR. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1752941474	71 Count	42 Count	42 Count
1752937872	59 Count	36 Count	36 Count
1752936071	50 Count	30 Count	30 Count
1752934270	41 Count	24 Count	24 Count
1752932470	33 Count	19 Count	19 Count
1752930669	24 Count	13 Count	13 Count
1752928868	13 Count	5 Count	5 Count
1752927067	9 Count	4 Count	4 Count
1752925267	6 Count	4 Count	4 Count
1752923466	1002 Count	611 Count	611 Count
1752921665	998 Count	610 Count	610 Count
1752919864	995 Count	610 Count	610 Count
1752918064	991 Count	609 Count	609 Count
1752916263	986 Count	607 Count	607 Count
1752914462	970 Count	594 Count	594 Count
1752912661	943 Count	569 Count	569 Count
1752910861	924 Count	552 Count	552 Count
1752909060	911 Count	541 Count	541 Count
1752907259	909 Count	541 Count	541 Count
1752905458	907 Count	541 Count	541 Count
1752903658	905 Count	541 Count	541 Count
1752901857	901 Count	539 Count	539 Count
1752900056	899 Count	539 Count	539 Count
1752898255	897 Count	539 Count	539 Count
1752896454	895 Count	539 Count	539 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)