EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1757879069	95 Count	544 Count
1757877266	94 Count	538 Count
1757875463	93 Count	535 Count
1757873660	92 Count	525 Count
1757871857	91 Count	518 Count
1757870054	90 Count	512 Count
1757868287	89 Count	509 Count
1757866483	88 Count	504 Count
1757864680	87 Count	498 Count
1757862877	86 Count	493 Count
1757861074	85 Count	490 Count
1757859271	84 Count	485 Count
1757857468	83 Count	480 Count
1757855665	82 Count	474 Count
1757853862	81 Count	469 Count
1757852059	80 Count	463 Count
1757850255	79 Count	455 Count
1757848452	78 Count	453 Count
1757846686	77 Count	449 Count
1757844883	76 Count	444 Count
1757843080	75 Count	440 Count
1757841277	74 Count	435 Count
1757839474	73 Count	430 Count
1757837671	72 Count	424 Count
1757835868	71 Count	420 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)