EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1760088653	51 Count	237 Count
1760086849	50 Count	232 Count
1760085047	49 Count	226 Count
1760083243	48 Count	221 Count
1760081440	47 Count	218 Count
1760079637	46 Count	211 Count
1760077834	45 Count	209 Count
1760076031	44 Count	203 Count
1760074228	43 Count	200 Count
1760072463	42 Count	194 Count
1760070660	41 Count	191 Count
1760068857	40 Count	188 Count
1760067054	39 Count	184 Count
1760065251	38 Count	180 Count
1760063448	37 Count	174 Count
1760061644	36 Count	168 Count
1760059841	35 Count	165 Count
1760058037	34 Count	154 Count
1760056234	33 Count	150 Count
1760054431	32 Count	144 Count
1760050860	30 Count	134 Count
1760049057	29 Count	130 Count
1760047254	28 Count	126 Count
1760045451	27 Count	122 Count
1760043648	26 Count	118 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)