This is the latest recevied telemetry packets stored in our database for station/object DL6DBZ-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
| Time | Celsius* | Rel_Hum* | Atm_Press* | GAS* | Value5* |
|---|---|---|---|---|---|
| 1793178446 | 19.1 C | 53.2 % | 1026.88 hPa | 77.56 % | 0 |
| 1793176636 | 19.8 C | 52.82 % | 1023 hPa | 52.69 % | 0 |
| 1793175731 | 19.8 C | 52.64 % | 1028 hPa | 48.76 % | 0 |
| 1793174826 | 19.9 C | 52.36 % | 1027.25 hPa | 44.95 % | 0 |
| 1793173921 | 20.2 C | 51.98 % | 1030 hPa | 37.83 % | 0 |
| 1793173016 | 20.6 C | 51.65 % | 1029.25 hPa | 25.26 % | 0 |
| 1793172111 | 20.5 C | 51.47 % | 0 hPa | 0 % | 0 |
| 1793171617 | 20.7 C | 50.23 % | 988.75 hPa | 0.63 % | 0 |
| 1793171383 | 20.9 C | 50.34 % | 1026.13 hPa | 8.36 % | 0 |
| 1793171236 | 21 C | 50.43 % | 1010.5 hPa | 17.96 % | 0 |
| 1793170920 | 20.9 C | 50.96 % | 1032 hPa | 58.27 % | 0 |
*Used Equation Coefficients:
Celsius: 0, 0.1, -50
Rel_Hum: 0, 0.01, 0
Atm_Press: 0, 0.125, 0
GAS: 0, 0.01, 0
Value5: 0, 1, 0
- The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
- Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value2 + b * value + c. - The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
- The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
- All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
- A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)