EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3MQD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3MQD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1779088433	167 Count	693 Count
1779087528	166 Count	690 Count
1779086625	165 Count	689 Count
1779085722	164 Count	686 Count
1779084819	163 Count	685 Count
1779083916	162 Count	682 Count
1779083013	161 Count	678 Count
1779082109	160 Count	677 Count
1779081206	159 Count	675 Count
1779080303	158 Count	672 Count
1779079400	157 Count	668 Count
1779078497	156 Count	665 Count
1779077593	155 Count	663 Count
1779076690	154 Count	661 Count
1779075787	153 Count	657 Count
1779074884	152 Count	654 Count
1779073981	151 Count	651 Count
1779073078	150 Count	649 Count
1779072174	149 Count	646 Count
1779071349	148 Count	644 Count
1779070446	147 Count	640 Count
1779069543	146 Count	639 Count
1779068640	145 Count	636 Count
1779067736	144 Count	636 Count
1779066833	143 Count	635 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)