EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9VRF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9VRF-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1783384800	359 Count	810 Count
1783383000	358 Count	807 Count
1783381199	357 Count	804 Count
1783379398	356 Count	801 Count
1783377598	355 Count	797 Count
1783375797	354 Count	794 Count
1783373996	353 Count	791 Count
1783372196	352 Count	788 Count
1783370395	351 Count	785 Count
1783368595	350 Count	782 Count
1783366794	349 Count	779 Count
1783364994	344 Count	776 Count
1783363194	343 Count	773 Count
1783361393	342 Count	770 Count
1783359592	341 Count	767 Count
1783357792	340 Count	764 Count
1783355991	339 Count	761 Count
1783354191	338 Count	758 Count
1783352390	337 Count	755 Count
1783350589	336 Count	753 Count
1783348789	335 Count	750 Count
1783346988	334 Count	747 Count
1783345188	333 Count	744 Count
1783343395	328 Count	741 Count
1783341595	327 Count	738 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)