EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB5BZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789218732	6 Count	198 Count
1789217298	5 Count	148 Count
1789215253	4 Count	69 Count
1789215246	3 Count	69 Count
1789215231	2 Count	69 Count
1789215226	1 Count	69 Count
1789215219	0 Count	69 Count
1789213491	9 Count	1062 Count
1789211446	8 Count	976 Count
1789209401	7 Count	887 Count
1789207356	6 Count	808 Count
1789205311	5 Count	695 Count
1789203266	4 Count	600 Count
1789201221	3 Count	510 Count
1789199176	2 Count	375 Count
1789197131	1 Count	188 Count
1789195981	0 Count	113 Count
1789193935	12 Count	1077 Count
1789191890	11 Count	988 Count
1789189845	10 Count	914 Count
1789187800	9 Count	835 Count
1789185755	8 Count	766 Count
1789183710	7 Count	688 Count
1789181665	6 Count	619 Count
1789179620	5 Count	515 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)