EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB5BZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1788626253	3 Count	494 Count
1788624208	2 Count	392 Count
1788622163	1 Count	287 Count
1788620117	0 Count	157 Count
1788618073	8 Count	1118 Count
1788616027	7 Count	981 Count
1788613982	6 Count	848 Count
1788612833	5 Count	777 Count
1788610788	4 Count	658 Count
1788608743	3 Count	544 Count
1788606698	2 Count	414 Count
1788604653	1 Count	275 Count
1788602608	0 Count	140 Count
1788600562	8 Count	1156 Count
1788598517	7 Count	983 Count
1788596473	6 Count	855 Count
1788594427	5 Count	715 Count
1788592382	4 Count	480 Count
1788591231	3 Count	397 Count
1788589186	2 Count	271 Count
1788587141	1 Count	188 Count
1788585097	0 Count	94 Count
1788583052	9 Count	1074 Count
1788581007	8 Count	962 Count
1788578962	7 Count	865 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)