EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762389552	86 Count	841 Count	41 Count
1762387752	85 Count	810 Count	41 Count
1762385951	84 Count	782 Count	41 Count
1762384151	83 Count	753 Count	41 Count
1762382350	82 Count	726 Count	41 Count
1762380549	81 Count	702 Count	41 Count
1762378756	76 Count	685 Count	41 Count
1762376955	72 Count	662 Count	38 Count
1762375154	71 Count	637 Count	38 Count
1762373354	70 Count	614 Count	38 Count
1762371553	69 Count	591 Count	38 Count
1762369752	68 Count	576 Count	38 Count
1762367951	67 Count	543 Count	38 Count
1762366151	66 Count	529 Count	38 Count
1762364350	65 Count	505 Count	38 Count
1762362549	64 Count	486 Count	38 Count
1762360749	63 Count	465 Count	38 Count
1762358948	62 Count	438 Count	38 Count
1762357155	57 Count	418 Count	38 Count
1762355354	53 Count	385 Count	35 Count
1762353553	52 Count	370 Count	35 Count
1762351753	47 Count	350 Count	31 Count
1762349952	36 Count	297 Count	21 Count
1762348151	35 Count	284 Count	21 Count
1762346351	34 Count	272 Count	21 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)