EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2OSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782968043	131 Count	993 Count	54 Count
1782966242	129 Count	983 Count	53 Count
1782964442	127 Count	929 Count	52 Count
1782962641	126 Count	908 Count	52 Count
1782960840	125 Count	900 Count	52 Count
1782959040	124 Count	893 Count	52 Count
1782957238	123 Count	881 Count	52 Count
1782953637	121 Count	867 Count	52 Count
1782951844	116 Count	860 Count	52 Count
1782950043	115 Count	853 Count	52 Count
1782948242	114 Count	846 Count	52 Count
1782946442	113 Count	838 Count	52 Count
1782942840	111 Count	815 Count	52 Count
1782941039	110 Count	804 Count	52 Count
1782939239	109 Count	797 Count	52 Count
1782937438	108 Count	790 Count	52 Count
1782935637	107 Count	734 Count	52 Count
1782932036	105 Count	699 Count	52 Count
1782930243	100 Count	692 Count	52 Count
1782928442	84 Count	660 Count	37 Count
1782926641	81 Count	631 Count	35 Count
1782924841	72 Count	596 Count	27 Count
1782923040	71 Count	561 Count	27 Count
1782919438	69 Count	532 Count	27 Count
1782917638	68 Count	516 Count	27 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)