EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773697847	16 Count	1042 Count
1773696044	15 Count	981 Count
1773694241	14 Count	917 Count
1773692437	13 Count	852 Count
1773690634	12 Count	774 Count
1773688831	11 Count	709 Count
1773687028	10 Count	634 Count
1773685225	9 Count	553 Count
1773683459	8 Count	491 Count
1773681656	7 Count	433 Count
1773679853	6 Count	367 Count
1773678050	5 Count	307 Count
1773676246	4 Count	264 Count
1773674443	3 Count	213 Count
1773672640	2 Count	150 Count
1773670837	1 Count	86 Count
1773669034	0 Count	52 Count
1773667230	15 Count	1041 Count
1773665427	14 Count	988 Count
1773663624	13 Count	930 Count
1773661859	12 Count	852 Count
1773660055	11 Count	802 Count
1773658252	10 Count	746 Count
1773656449	9 Count	684 Count
1773654646	8 Count	627 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)