EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1772276591	1 Count	108 Count
1772274787	0 Count	52 Count
1772272984	19 Count	1013 Count
1772271181	18 Count	968 Count
1772269378	17 Count	925 Count
1772267574	16 Count	877 Count
1772265771	15 Count	825 Count
1772263968	14 Count	763 Count
1772262165	13 Count	703 Count
1772260362	12 Count	660 Count
1772258559	11 Count	612 Count
1772256755	10 Count	541 Count
1772254990	9 Count	467 Count
1772253187	8 Count	398 Count
1772251383	7 Count	345 Count
1772249580	6 Count	303 Count
1772247777	5 Count	272 Count
1772245974	4 Count	237 Count
1772244171	3 Count	199 Count
1772242367	2 Count	145 Count
1772240564	1 Count	94 Count
1772238761	0 Count	44 Count
1772236958	20 Count	1040 Count
1772235155	19 Count	998 Count
1772233390	18 Count	956 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)