EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5CZL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5CZL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789238408	263 Count	325 Count	187 Count
1789237506	260 Count	321 Count	185 Count
1789236605	257 Count	318 Count	183 Count
1789235704	254 Count	315 Count	181 Count
1789234802	251 Count	311 Count	179 Count
1789233901	249 Count	309 Count	178 Count
1789233000	246 Count	307 Count	176 Count
1789232099	237 Count	298 Count	168 Count
1789231197	220 Count	281 Count	152 Count
1789230296	215 Count	276 Count	148 Count
1789229395	212 Count	272 Count	146 Count
1789228494	209 Count	269 Count	144 Count
1789227592	206 Count	266 Count	142 Count
1789226722	203 Count	261 Count	140 Count
1789225821	200 Count	258 Count	138 Count
1789224920	197 Count	255 Count	136 Count
1789224018	194 Count	252 Count	134 Count
1789223117	191 Count	249 Count	132 Count
1789222216	188 Count	246 Count	130 Count
1789221315	185 Count	243 Count	128 Count
1789220413	183 Count	241 Count	127 Count
1789219512	180 Count	238 Count	125 Count
1789218611	177 Count	236 Count	123 Count
1789217709	175 Count	235 Count	122 Count
1789216807	172 Count	232 Count	120 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)