EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5CZL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5CZL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1793185912	886 Count	935 Count	647 Count
1793185010	882 Count	931 Count	644 Count
1793184109	880 Count	929 Count	643 Count
1793183207	876 Count	925 Count	640 Count
1793182336	873 Count	922 Count	638 Count
1793181435	870 Count	919 Count	636 Count
1793180533	867 Count	916 Count	634 Count
1793179632	864 Count	913 Count	632 Count
1793178731	861 Count	910 Count	630 Count
1793177830	858 Count	907 Count	628 Count
1793176928	855 Count	904 Count	626 Count
1793176027	852 Count	901 Count	624 Count
1793175126	849 Count	898 Count	622 Count
1793174225	846 Count	895 Count	620 Count
1793173323	843 Count	892 Count	618 Count
1793172422	840 Count	889 Count	616 Count
1793171520	837 Count	886 Count	614 Count
1793170619	834 Count	883 Count	612 Count
1793169718	831 Count	880 Count	610 Count
1793168817	828 Count	877 Count	608 Count
1793167915	825 Count	875 Count	606 Count
1793167014	818 Count	869 Count	600 Count
1793166113	800 Count	852 Count	583 Count
1793165211	797 Count	849 Count	581 Count
1793164310	794 Count	846 Count	579 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)