EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IWE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IWE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789314137	5 Count	110 Count
1789312342	30 Count	1138 Count
1789310548	27 Count	992 Count
1789308740	24 Count	844 Count
1789306939	21 Count	708 Count
1789305138	18 Count	582 Count
1789303337	15 Count	460 Count
1789301537	12 Count	364 Count
1789299736	8 Count	241 Count
1789297940	2 Count	116 Count
1789296140	28 Count	1007 Count
1789294338	25 Count	840 Count
1789292538	16 Count	683 Count
1789290737	13 Count	455 Count
1789288936	10 Count	272 Count
1789287135	7 Count	148 Count
1789285335	3 Count	3 Count
1789283538	17 Count	990 Count
1789281737	14 Count	834 Count
1789279937	11 Count	652 Count
1789278136	8 Count	478 Count
1789276335	5 Count	311 Count
1789274534	2 Count	144 Count
1789272733	24 Count	1023 Count
1789270933	20 Count	869 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)